![]() ![]() Programming Code For Interference Eliminator To return to continue programming, press down on MENU or press the PTT to leave the programming mode entirely. #Motorola radio management device programmer plusUsing the plus or minus buttons available, choose the channel you prefer from the list of the available options. While still in programming mode, press the Menu option until the number 1 appears and the tally number on every frequency displays on the prompt. In a Motorola radio, the channel option stays atop the list available on the menu, followed by the frequency modulation. Once you enter programmable mode, press down on the “menu” option to display the number of channels available. Picking A Channel From The List Of Available Options Press and hold onto the Push-To-Talk button to leave the programming mode or press the menu to continue with the programming. Using the plus and minus button (+ or -) for navigation, pick from the available channels your preferences and save them. Press and hold down on the Menu option until you notice an indicator displaying an available channel(s). To scan the Motorola device’s number of available options, do so using the following steps below.Įnter the programming mode using the steps explained above. We will, however, be taking you through a step-by-step approach programming each of them below. Similarly, if you press and hold down both the PTT button and the button on the reverse side of the device firmly together, you will notice a beep followed by a green flash.Īs listed above are four main programmable functions in a Motorola two-way radio device. ![]() Otherwise, you will lose all that you are programmed if you mistakenly release the PTT button. ![]() When trying to program, make sure to press and hold down tightly on the push-to-talk button to endure that all you are programming into the device are appropriately saved. There will be a beep to indicate that the device is on and ready for the programming process.ĭifferent indicator command signs like PROG, FREQ, and CODE will pop up to represent “programming, frequency modulation, and code, respectively. Push and hold onto the Push-to-Talk (PTT) and MON button for three seconds while switching the radio on. To start up with the programmable option on your Motorola radio device, ensure that your radio is off and fully charged. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |